REAR-PANEL CONNECTIONS
¤ Subwoofer Out: Connect these jacks to the line-level inputs of a powered subwoofer. If an external subwoofer amplifier is used, connect these jacks to the subwoofer amplifier inputs. When a single, mono subwoofer is used, or if the subwoofer or its amplifier has only a single line-level input jack, make the connection to the bottom jack on the HK 3480. � Speaker 1 Terminals: Connect these terminals to the appropriate terminals on your speakers. � Speaker 2 Terminals: Connect these terminals to the appropriate terminals on your speakers. � Accessory Outlets: These outlets may be used to power low-current-draw devices such as CD players or cassette decks. The power to these outlets remains on as long as the receiver itself is on. When the receiver is placed in the Standby mode, power to these outlets is removed. NOTE: The power consumption of the devices plugged into these outlets should not exceed 100 watts. � Power Cable: Connect the AC plug to a nonswitched AC wall output. � Remote IR Out: This connection permits the IR sensor in the receiver to serve other remote-controlled devices. Connect this jack to the �IR In� jack on Harman Kardon (or other compatible) equipment. ° Remote IR In: If the HK 3480�s front-panel IR sensor is blocked due to cabinet doors or other obstructions, an external IR sensor may be used. Connect the output of the sensor to this jack. · Video Monitor Output: Connect this jack to the composite video input of your TV or video display device. Doing so will enable you to view the video signal of a properly connected video source device, when that source input is selected. When an audioonly source is selected, the Video Monitor Output · will not transmit a video signal. a AM Antenna: Connect the AM loop antenna supplied with the receiver to these terminals. If an external AM antenna is used, make connections to the AM and GND terminals in accordance with the instructions supplied with the antenna. b FM Antenna: Connect an indoor or external FM antenna to this terminal.